M/T Mainshaft Bearing and Oil Seal Replacement

Special Tools Required
Adjustable bearing puller, 25-40 mm (  07JAC-PH80100)
 

Bearing remover shaft (  07JAC-PH80200)
 
Slide hammer (  07741-0010201)
 
Driver (  07749-0010000)
 
Attachment, 37 x 40 mm (  07746-0010200)
 
Attachment, 52 x 55 mm (  07746-0010400)
 


1.Remove the differencial assembly.

2.Remove the ball bearing (A) from the clutch housing (B) using the special tool.

 

3.Remove the oil seal (A) from the clutch side.

 

4.Drive the new oil seal in from the transmission side using the special tools.

 

5.Drive the new ball bearing (A) in from the transmission side using the special tools.