DTC Troubleshooting: 1-3

DTC 1-3:  Short to Another Wire or Decreased Resistance in Driver's Airbag Inflator

Special Tools Required
SRS inflator simulator (  07SAZ-TB4011A)
 

SRS simulator lead F (  07XAZ-SZ30100)
 


1.Erase the DTC memory.

2.Turn the ignition switch ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.

Does the SRS indicator stay on?


YES - Go to 3.


NO - Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures.


3.Turn the ignition switch OFF. Disconnect the battery negative cable, and wait for 3 minutes.

4.Disconnect the D1i connector from the D1o connector (A).

 

5.Connect the special tool (2 W connector) to the D1o connector (A).

6.Reconnect the battery negative cable.

7.Erase the DTC memory.

8.Read the DTC.

Is DTC 1-3 indicated?


YES - Go to 9.


NO - Short in the driver's airbag; replace the driver's airbag.n


9.Disconnect the battery negative cable, and wait for 3 minutes.

10.Disconnect the U1o connector (A) from the SRS unit. Do not disconnect SRS simulator lead F from cable reel 4P connector.

 

11.Disconnect the SRS inflator simulator (special tool) from the SRS simulator lead F.

12.Install the special tool (070AZ-SAA0100) to No. 7 and No. 8 terminals of the U1o connector.

13.Check resistance between the terminals of SRS simulator lead F. There should be 1 MW or more.

 

Is the resistance as specified?


YES - Replace the the SRS unit.n


NO - Go to 14.


14.Disconnect the D2o connector (A) from the D2i connector (B).

 

15.Check resistance between the terminals of SRS simulator lead F. There should be 1 MW or more.

 

Is the resistance as specified?


YES - Replace the dashboard wire harness.n


NO - Replace the cable reel.n