DTC Troubleshooting: P0775 (39-2)

DTC P0775:  Problem in CVT Driven Pulley Pressure Control Valve Circuit

For KB, KE, KG, and KQ Models


NOTE:

1.Disconnect CVT driven pulley pressure control valve connector.

2.Measure the resistance between connector terminals at the control valve connector.

 

Is the resistance 3.8-6.8 W?


YES - Go to 3.


NO - Faulty the CVT driven pulley pressure control valve, replace the control valve body.n

3.Disconnect PCM connectors A (31P).

4.Check for continuity between PCM connector terminals A3 and body ground, and between A5 and body ground.

 

Is there continuity?


YES - Go to 5.


NO - Repair open in the wire between PCM connector terminals A3 and A5, and ground (G101), or repair poor ground (G101).n

5.Disconnect PCM connectors B (24P) and C (22P).

6.Check for continuity between PCM connector terminal B7 and body ground.

 

Is there continuity?


YES - Repair short in the wire between PCM connector terminal B7 and CVT driven pulley pressure control valve connector.n


NO - Go to 7.


7.Check for continuity between PCM connector terminal C1 and body ground.

 

Is there continuity?


YES - Repair short in the wire between PCM connector terminal C1 and CVT driven pulley pressure control valve connector.n


NO - Go to 8.

8.Connect CVT driven pulley pressure control valve connector.

9.Measure the resistance between PCM connector terminals B7 and C1.

 

Is the resistance 3.8-6.8 W?


YES - Update the PCM if it does not have the latest software, or substitute a known-good PCM, then recheck. If the symptom/indication goes away with a known-good PCM, replace the original  PCM.n


NO - Go to 10.

10.Disconnect CVT driven pulley pressure control valve connector.

11.Check for continuity between PCM connector terminal B7 and CVT driven pulley pressure control valve connector terminal No. 1.

 

Is there continuity?


YES - Repair loose terminal or open in the wire between PCM connector terminal C1 and CVT driven pulley pressure control valve connector.n


NO - Repair open in the wire between PCM connector terminal B7 and CVT driven pulley pressure control valve connector.n