Skip to main content
Radiator and A/C Condenser Fan, Motor, and Shroud Removal and Installation

Removal
  1. Remove the right side splash shield.
  1. Raise the vehicle on the lift to full height.

  1. Remove the A/C compressor clutch connector (A) from the clamp, then remove the harness clamps (B).
  1. Lower the vehicle on the lift.

  1. Disconnect the fan motor connectors (A), the hood latch switch connector (B), and the horn connector (C), then remove the ground cable (D) and the harness clamps (E).
RHD model
LHD model

  1. Remove the bulkhead mounting bolts, and remove the hood opener cable clamp (A), then remove the bulkhead (B).

  1. Remove the coolant reservoir (A).
  1. Remove the condenser fan shroud assembly (B), then remove the radiator fan shroud assembly (C) from condenser fan shroud side.

  1. Disassemble the fan shrouds.

Installation
  1. Assemble the fan shrouds.

  1. Install the radiator fan shroud assembly (A), then install the condenser fan shroud assembly (B).
  1. Install the coolant reservoir (C).

  1. Install the hood opener cable clamp (A), then install the bulkhead (B).
  1. Apply body paint to the bulkhead mounting bolts.

  1. Connect the fan motor connectors (A), the hood latch switch connector (B), and the horn connector (C), then install the ground cable (D) and the harness clamps (E).
  1. Raise the vehicle on the lift to full height.
RHD model
LHD model

  1. Install the A/C compressor clutch connector (A) to the clamp, then install the harness clamps (B).
  1. Lower the vehicle on the lift.

  1. Install the right side splash shield.