Skip to main content
CMP Pulse Plate Removal and Installation

Removal
  1. Remove the following engine wire harness connectors and wire harness clamps from the cylinder head:
    • Four injector connector
    • Engine coolant temperature (ECT) sensor 1 connector
    • Camshaft position (CMP) sensor connector
    • Air fuel ratio (A/F) sensor connector
    • Secondary heated oxygen sensor (secondary HO2S) connector
  1. Remove the camshaft thrust cover.

  1. Hold the camshaft with an open-end wrench, then loosen the bolt.

  1. Remove the camshaft position (CMP) pulse plate.

Installation
  1. Install the CMP pulse plate.

  1. Hold the camshaft with an open-end wrench, then tighten the bolt.
    Specified Torque
    14 x 1.5 mm 34 N·m (3.5 kgf·m, 25 lbf·ft)


  1. Install the camshaft thrust cover (A) with new O-ring (B).
  1. Install the following engine wire harness connectors and wire harness clamps from the cylinder head:
    • Four injector connector
    • Engine coolant temperature (ECT) sensor 1 connector
    • Camshaft position (CMP) sensor connector
    • Air fuel ratio (A/F) sensor connector
    • Secondary heated oxygen sensor (secondary HO2S) connector