Skip to main content
Wheel Speed Sensor Replacement

Front
  1. Turn the ignition switch to LOCK (0).
  1. Remove the grommet (A), then disconnect the wheel speed sensor connector (B).
  1. Remove the bracket (C), the clip (D), and the stay (E).
  1. Remove the bolt and the wheel speed sensor (F).
  1. Install the wheel speed sensor in the reverse order of removal, and note these items:
    • Install the sensor carefully to avoid twisting the wires.
    • If the wheel speed sensor comes in contact with the wheel bearing, it is faulty.
    • Make sure the grommet is installed properly.
  1. Start the engine, and make sure the ABS indicator go off.
  1. Test-drive the vehicle, and make sure the ABS indicator do not come on.

Rear
  1. Turn the ignition switch to LOCK (0).
  1. Pull back the carpet under the rear seat, then disconnect the wheel speed sensor connector (A).
  1. Remove the grommet (B), the bracket (C), the clips (D), and the stay (E).
  1. Remove the bolt and the wheel speed sensor (F).
  1. Install the wheel speed sensor in the reverse order of removal, and note these items:
    • Install the sensor carefully to avoid twisting the wires.
    • If the wheel speed sensor comes in contact with the hub bearing unit, it is faulty.
    • Make sure the grommet is installed properly.
  1. Start the engine, and make sure the ABS indicator go off.
  1. Test-drive the vehicle, and make sure the ABS indicator do not come on.