Skip to main content
Rear Brake Disc Replacement

NOTE: Keep any grease off the brake disc and brake pads.
  1. Remove the rear wheel.
  1. Release the parking brake lever fully.
  1. Remove the caliper bracket (A) from the knuckle.

  1. Remove the brake disc flat screws (A).
  1. Remove the brake disc (B) from the hub bearing unit.
    NOTE: If the brake disc is stuck to the hub bearing unit, thread two 8 x 1.25 mm bolts (C) into the brake disc to push it away from the hub bearing unit. Turn each bolt 90 degrees at a time to prevent the brake disc from binding.
  1. Install the brake disc in the reverse order of removal, and note these items:
    • Before installing the brake disc, clean the mating surfaces of the hub bearing unit and the inside of the brake disc.
  1. Clean the mating surfaces of the brake disc and the inside of the wheel, then install the rear wheel.