Skip to main content
Intermediate Shaft Disassembly

Special Tools Required

Half shaft base

Oil seal driver, 44.5 mm
  1. Remove the outer seal (A), and the external snap ring (B) from the intermediate shaft (C).

  1. Press the intermediate shaft (A) out of the intermediate shaft bearing (B) using a press. Be careful not to damage the bearing support ring (C) on the intermediate shaft during disassembly.

  1. Remove the internal snap ring (A) from the bearing support (B).

  1. Press intermediate shaft bearing (A) out of the bearing support (B) using the 44.5 mm oil seal driver (C), the half shaft base (D) and a press.