Skip to main content
Front Passenger's Airbag Replacement

Removal
  1. Do the battery terminal disconnection procedure, then wait for 3minutes before starting work.
  1. Remove these items:
  1. Remove the connector clip, then disconnect the front passenger's airbag 4P connector (A) from the dashboard wire harness (B).

  1. Remove the screw (A) from the passenger's lid.
  1. Remove the three mounting bolts (B) from the bracket.

  1. Release the hooks (A), of the front passenger's lid (B) from the Audio panel.
  1. Pull up the front edges of the front passenger's lid to release the hooks (C).

  1. Remove the front passenger's airbag assembly (A) out of the dashboard. If you are replacing only the front passenger's lid, go to Step 8 .
    NOTE: The front passenger's lid has pawls (B, C) on each side which attach it to the dashboard.

  1. Cut the four parts (A) of the front passenger's lid (B) as shown, and remove the front passenger's airbag.
    NOTE:
    • Always replace the front passenger's lid whenever you remove the airbag from the panel.
    • Replace the airbag if the airbag mounting hooks or its housing is damaged.

  1. Insert the hooks (A) of the front passenger's airbag housing into the new front passenger's lid, then insert the other hooks (B) into the panel.
    NOTE:
    • Make sure there are no objects between the airbag and the front passenger's lid.
    • Make sure the airbag is fully seated, and make sure the front passenger's lid is not deformed or damaged after the airbag is in place.
    • Do not use tools when detaching the front passenger's airbag in order to protect it.

Installation
  1. Place the front passenger's airbag assembly (A) into the dashboard. Torque the front passenger's airbag mounting bolts (B).
  1. Install the screws (C) from the front passenger's lid.

  1. Connect the front passenger's airbag 4P connector (A) to the dashboard wire harness (B), then connect the connector clip. Reinstall the glove box.
  1. After installing the airbag, confirm proper system operation: Turn the ignition switch to ON (II); the SRS indicator should come on for about 6 seconds and then go off.