Skip to main content
Front Impact Sensor Replacement

Removal
  1. Do the battery terminal disconnection procedure, then wait for 3 minutes before starting work.
  1. Disconnect the engine compartment wire harness 2P connector (A). Using a TORX T30 bit, remove the TORX bolt (B), then remove the front impact sensor (C).

Installation
  1. Install the front impact sensor with a new TORX bolt (A), then connect the engine compartment wire harness 2P connector (B) to the front impact sensor (C).
  1. Confirm proper SRS operation: Turn the ignition switch to ON (II); the SRS indicator should come on for about 6 seconds and then go off.
  1. Reinstall all removed parts.