Skip to main content
OPDS Unit Replacement

Removal
  1. Do the battery terminal disconnection procedure, then wait for 3 minutes before starting work.
  1. Remove the cover (A), then disconnect the OPDS unit 18P connector (B) and sensor connectors (C) from the OPDS unit (D).
  1. Remove the two nuts (E) and the OPDS unit.

Installation
  1. Place the OPDS unit (A) on the seat-back frame. Tighten the new nuts (B), and connect the OPDS unit harness 18P connector (C) and sensor connectors (D) to the OPDS unit. Reinstall the cover (E).
  1. Install the front seat assembly, then connect the front passenger's side airbag harness 2P connector.
  1. Set the seat-back in the normal position, and make sure there is nothing on the front passenger's seat.
  1. Confirm proper SRS operation: Turn the ignition switch to ON (II); the SRS indicator should come on for about 6 seconds and then go off.