Skip to main content
Side Curtain Airbag Replacement

Removal
NOTE:
  1. Do the battery terminal disconnection procedure, then wait for 3 minutes before starting work.
  1. Disconnect the floor wire harness 2P connectors (A) from the side curtain airbags.

  1. Remove the side airbag mounting bolts (A) and mounting screws (B) from the bracket. Detach the clip (C), then remove the side curtain airbag (D).

Installation
NOTE:
  • If the airbag is frayed, or has any other visible damage, replace it. Do not attempt to repair an airbag.
  • When you install the airbag, make sure it is not twisted, and that it is not caught between the inflator bracket by the bracket bolts.
  • Make sure that the side curtain airbag inflator retainer is installed properly. Otherwise the airbag could incorrectly deploy and cause damage or injuries.
  • Make sure you have the slack or no cutting and peeling. If tape has slack or cutting, and peeling side curtain airbag should be replacement.
  1. Place the side curtain airbag assembly on the side of the roof, and fit its clip (A) into the holes in the body. Tighten the new side curtain airbag mounting bolts (B) and mounting screws (C).

  1. Connect the floor wire harness 2P connectors (A) to the side curtain airbags.
  1. After installing the side curtain airbag, confirm proper system operation: Turn the ignition switch to ON (II); the SRS indicator should come on for about 6 seconds and then go off.
  1. Install all removed parts.