Skip to main content
Center Console Removal/Installation - Without Seat Heater

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.
  • Take care not to scratch the front seat, dashboard, and related parts.
  • When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
  • RHD model is shown; LHD model is symmetrical.
  1. M/T model: Remove the shift knob (A).

  1. Remove the center console (A).
    Remove the parking brake cover lid (B), separation box (C), and center console lid (D).
    Remove the console box mat (E), then remove the bolt (F) and the clips (G).
    Lift the rear of the console up to detach the clip (H).
  1. Install the trim in the reverse order of removal, and note these items:
    • Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
    • Push the clips into place securely.
    • Make sure the wire harness is not pinched.