Skip to main content
Dashboard Center Lower Trim Removal/Installation

NOTE:
  • Take care not to scratch the dashboard and its related parts.
  • When removing components, use the trim tools or equivalent.
  • RHD model is shown; LHD model is symmetrical.
  1. Remove the center lower trim (A).
    -1.
    Use the trim tool to pry the gap between the dashboard (B) and the upper side of the center lower trim partially out and release the clips and hooks (C).
    -2.
    Pull out the center lower trim slightly toward you and disconnect the accessory power socket connector (D) and USB connector (E) (if equipped).
  1. Install the trim in the reverse order of removal, and note these items:
    • Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
    • Push the clips and the hooks into place securely.
    • Make sure the connectors are plugged in properly.