Skip to main content
Dashboard Driver's Undercover Removal/Installation - With HFT unit

With HFT Unit
NOTE:
  • Take care not to scratch the dashboard and its related parts.
  • LHD model is shown; RHD model is symmetrical.
  1. Remove the driver's dashboard undercover (A).
    -1.
    Turn the lock knob (B) 90 °.
    -2.
    Gently pull down the rear edge to detach the clip.
    -3.
    Pull the undercover away to release the pins (C) from the kick panel (D).
    -4.
    Detach the clip (E) and disconnect the HFT unit connector (F), then remove the undercover.
  1. Install the undercover in the reverse order of removal, and note these items:
    • If the clip is damaged or stress-whitened, replace it with a new one.
    • Push the clip and pins into place securely.