Skip to main content
Interior Trim Removal/Installation - Rear Side Areas

NOTE:
  • Put on gloves to protect your hands.
  • Take care not to bend or scratch the trim and panels.
  • When removing components, use the trim tools or equivalent.
  • RHD model is shown; LHD model is symmetrical.
  1. Remove these items:
  1. For some models: Release the buttons (A), then remove the rear shelf (B).

  1. Remove the cargo area side trim panel (A).
    -1.
    Release the rear seat belt (B) from the guide (C) of the cargo area side trim panel.
    -2.
    Detach the clips (D, E), then pull the panel back to remove it from the rear seat back striker (F).
    -3.
    Left side: Disconnect the cargo area light connector (G).
  1. Install the panel in the reverse order of removal, and note these items:
    • Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
    • Push the clips into place securely.
    • Make sure the cargo area light connector is plugged in properly.
    • When installing the panel, make sure there are no pinches in the seat belt.