Skip to main content
Multi-information Display Select/Reset/Information/Switch Test/Replacement

  1. Disconnect the 20P connector (A) from the cable reel.

  1. Check for continuity between the terminals in each switch position according to the table.
  1. Without cruise control: if the check is not as specified, replace the switch. If the switch is OK, but the system does not operate, check for the cable reel.
    With cruise control: if the check is not as specified, go to Step 5 . If the check is OK, but the system does not operate, check for the cable reel.


  1. Check for continuity between the terminal (B) in each switch position according to the table.
  1. If the continuity is not as specified, replace the switch. If the switch is OK, but the system does not operate, check for an open in the wire between the switch and the cable reel.