Skip to main content
Power Mirror Replacement

NOTE:
  • Put on gloves to protect your hands.
  • Take care not to scratch the door and related parts.
  • RHD model is shown; LHD model is symmetrical.
  1. Carefully pull the bottom edge of the mirror mount cover (A) out to release the hooks (B), and remove the cover by lifting it upward to release the hooks (C, D).

  1. Remove the plastic cover as needed, then disconnect the connector (A).

  1. While holding the mirror (A), remove the nuts.

  1. While holding the mirror (A), detach the clip (B) and pull the harness (C) out through the hole in the door. Take care not to scratch the door.
  1. Install the mirror in the reverse order of removal, and note these items:
    • Make sure the connector is plugged in properly.
    • Check if the clip is damaged or stress-whitened, and if necessary, replace it with a new one.
    • Push the clip and hooks into place securely.