Skip to main content
Front Seat Recline Cover Removal/Installation

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.
NOTE:
  • Put on gloves to protect your hands.
  • Take care not to tear the seams or damage the seat covers.
  • When removing components, use the trim tools or equivalent.
  • RHD model is shown; LHD model is similar.
Outer recline cover
  1. Manual height adjustable seat: Pull back the cap (A) to release the hooks (B), and remove the screws, then remove the height handle (C).

  1. Remove the recline outer cover (A).
    -1.
    Fold back the seat to fully.
    -2.
    Remove the recline knob (B), and remove the screw.
    -3.
    Using a trim tool, and release the hooks (C) of the outer cover from the recline inner cover (D).
    -4.
    Detach the clip by pulling the outer cover back by hand.
    -5.
    Gently pull out the outer cover and remove it.

Inner recline cover
  1. Remove the recline inner cover (A).
    -1.
    Release the hooks (B) of the recline inner cover from the seat cushion frame.
    -2.
    Pull out the cover by removing the holder of the cover from the seat cushion frame pipe (C).
  1. When installing the inner cover; securely fit the hooks on the seat cushion frame first, next fit the holder of the cover on the cushion pipe.
Driver's seat
Passenger's seat