Skip to main content
Immobilizer Key Registration

NOTE:
  • The HDS is required for registration of the immobilizer keys.
  • Check for aftermarket electrical equipment that can cause problems with transponder operation.
  • The immobilizer control unit-receiver can store up to six immobilizer Keys.
Replace any of the keys
NOTE: If any of the registered keys were lost, do the following procedure to delete the lost registered key.
  1. Have at least one original key, all other keys to be registered and the immobilizer ECM/PCM code.
  1. Connect the HDS to the data link connector.
  1. Turn the ignition switch to ON (II).
  1. Select ‘‘IMMOBILIZER'' from the ‘‘SYSTEM SELECTION MENU''.
  1. Select ‘‘KEYS'' from the ‘‘IMMOBILIZER MENU'', then select ‘‘REWRITE KEYS''.
  1. Select ‘‘REWRITE KEYS'' from the ‘‘KEYS''.
  1. Do the registration according to the instruction of HDS screen.
  1. Check if the engine can be started by all the registered keys.
All keys are lost
  1. Prepare all new keys and have the immobilizer ECM/PCM code.
  1. Connect the HDS to the data link connector.
  1. Turn the ignition switch to ON (II).
  1. Select ‘‘IMMOBILIZER'' from the ‘‘SYSTEM SELECTION MENU''.
  1. Select ‘‘KEYS'' from the ‘‘IMMOBILIZER MENU'', then select ‘‘REWRITE KEYS''.
  1. Select ‘‘ALL KEYS LOST'' from the ‘‘KEYS''.
  1. Do the registration according to the instruction of HDS screen.
  1. Check if the engine can be started by all the registered keys.