Skip to main content
Battery Removal/Installation

NOTE: The battery terminal disconnection/reconnection procedure must be done before and after doing this procedure. Some systems store data in memory that is lost when the battery is disconnected.
Removal
  1. Remove the two nuts (A) securing the battery setting plate (B), then remove the battery setting plate and the battery (C).

Installation
  1. Install the battery (A), then install the battery setting plate (B).
  1. Tighten the two nuts (C) equally until the battery is stable.
    NOTE: Do not deform the battery setting plate by tightening the nuts too much.
  1. NOTE: Make sure the positive terminal and the negative terminal are not reverse-connected.