Skip to main content
Honda Fit Jazz GE6 GE8
Front Door Glass and Regulator Replacement
Put on gloves to protect your hands.
Take care not to scratch the door and related parts.
RHD model is shown; LHD model is symmetrical.
Remove the these items:
Disconnect the power door lock actuator connector.
Remove the plastic cover.
Carefully raise the glass (A) until you can see the bolts, then remove them. Carefully pull the glass out through the window slot.
NOTE: Take care not to drop the glass inside the door.
Disconnect the connector (A) from the regulator (B).
Remove the bolts, and release the hooks, then remove the regulator through the hole in the door.
Apply multipurpose grease to all the sliding surfaces of the regulator (A) where shown.
Install the glass and regulator in the reverse order of removal, and note these items:
Raise and lower the glass to see if it moves freely without binding.
Make sure that there is no clearance between the glass and glass run channel when the glass is closed.
Adjust the position of the glass as necessary.
Do the power window control unit reset procedure.
When reinstalling the door panel, make sure the plastic cover is installed properly and sealed around its outside perimeter to seal out water.
Check for water leaks.
Test-drive and check for wind noise and rattles.
Make sure the power door locks, windows and power mirror operate properly.