Skip to main content
Resetting the Power Window Control Unit (Master Switch)

Driver's Window Resetting and Learning
Resetting and learning the driver's window is required when any of the following have occurred:
  • Power window master switch replacement
  • Power window regulator replacement or repair
  • Power window motor replacement or repair
  • Window run channel replacement or repair
  • Driver's door glass replacement or repair
  • Power is removed from the power window control unit while the power window key-off operation timer is ON.
  1. Turn the ignition switch to LOCK (0).
  1. Press and hold the driver's window DOWN switch.
  1. Turn the ignition switch to ON (II).
  1. Release the driver's window DOWN switch.
  1. Repeat Step 1 −4 three more times.
  1. Check if the AUTO UP and AUTO DOWN functions still work.
    • If they still work, AUTO UP and AUTO DOWN functions have not been cleared; go back to Step 1 .
    • If they do not, go to Step 7 .
  1. Turn the ignition switch to ON (II).
  1. Move the driver's window all the way down by using the driver's window DOWN switch.
  1. Pull up and hold the driver's window UP switch until the window reaches the fully closed position, then continue to hold the switch for 1 second.
  1. Make sure that the power window control unit is reset and learned by using the driver's window AUTO UP and AUTO DOWN functions.