Skip to main content
EPS DTC Troubleshooting: 61-03

DTC 61-03:
 Open the EPS Motor Harness (Regular Diagnosis)
  1. Turn the ignition switch to ON (II).
  1. Clear the DTC with the HDS.
  1. Turn the ignition switch to LOCK (0).
  1. Start the engine.
  1. Turn the steering wheel from lock to lock several times, and hold the steering wheel for 10 seconds or more.
  1. Check for DTCs with the HDS.
Is DTC 61-03 indicated?
YES -
Go to Step 7 .
NO -
Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the EPS motor and the EPS control unit.■
  1. Turn the ignition switch to LOCK (0).
  1. Disconnect the EPS control unit connector B (2P) and the EPS motor 2P connector.
  1. Check for continuity between EPS control unit connector B (2P) terminal No. 2 and EPS motor 2P connector terminal No. 1.
Is there continuity?
YES -
Go to Step 10 .
NO -
Repair open in the wire between the EPS control unit and EPS motor.■

  1. Check for continuity between EPS control unit connector B (2P) terminal No. 1 and EPS motor 2P connector terminal No. 2.
Is there continuity?
YES -
Go to Step 11 .
NO -
Repair open in the wire between the EPS control unit and EPS motor.■

  1. On the EPS motor side, check for continuity between EPS motor 2P connector terminals No. 1 and No. 2.
Is there continuity?
YES -
Check for loose terminals in the EPS control unit connectors and repair if necessary. If no poor connections are found, replace the EPS control unit.
NO -