Skip to main content
VSA DTC Troubleshooting: 11-14, 13-14, 15-14, 17-14

DTC 11-14:
 Right-front Wheel Speed Sensor Power Source Malfunction
DTC 13-14:
 Left-front Wheel Speed Sensor Power Source Malfunction
DTC 15-14:
 Right-rear Wheel Speed Sensor Power Source Malfunction
DTC 17-14:
 Left-rear Wheel Speed Sensor Power Source Malfunction
  1. Turn the ignition switch to ON (II).
  1. Clear the DTC with the HDS.
  1. Turn the ignition switch to LOCK (0), then turn it to ON (II) again.
  1. Check for DTCs with the HDS.
Is DTC 11-14, 13-14, 15-14, and/or 17-14 indicated?
YES -
Go to Step 5 .
NO -
Intermittent failure, the system is OK at this time. Check for loose terminals between the wheel speed sensor 2P connector and the VSA modulator-control unit 36P connector. Refer to intermittent failures troubleshooting.
  1. Turn the ignition switch to ON (II).
  1. Check for DTCs with the HDS.
Is DTC 11-14, 13-14, 15-14, and/or 17-14 indicated?
YES -
Check for loose terminals in the VSA modulator-control unit 36P connector. If the VSA modulator-control unit was updated, substitute a known-good VSA modulator-control unit, then retest. If the VSA modulator-control unit was substituted, go to Step 1 .
NO -
If the VSA modulator-control unit was updated, troubleshooting is complete. If the VSA modulator-control unit was substituted, replace the original VSA modulator-control unit. If any other DTCs are indicated, go to the indicated DTCs troubleshooting.■