Skip to main content
VSA DTC Troubleshooting: 54-03, 54-04, 54-21

DTC 54-03:
 Fail-safe Relay 1 Stuck ON
DTC 54-04:
 Fail-safe Relay 1 Stuck OFF (Initial)
DTC 54-21:
 Fail-safe Relay 1 Stuck OFF (Main)
  1. Turn the ignition switch to ON (II).
  1. Clear the DTC with the HDS.
  1. Turn the ignition switch to LOCK (0), then turn it to ON (II) again.
  1. Check for DTCs with the HDS.
Is DTC 54-03, 54-04, or 54-21 indicated?
YES -
Go to Step 5 .
NO -
Intermittent failure, the system is OK at this time.■
  1. Turn the ignition switch to LOCK (0).
  1. Check the No. 37 (30 A) fuse in the under-hood fuse/relay box.
Is the fuse blown?
YES -
Go to Step 7 .
NO -
Reinstall the checked fuse, then go to Step 10 .
  1. Check for continuity between VSA modulator-control unit 36P connector terminal No. 12 and body ground.
Is there continuity?
YES -
Repair short to body ground in the wire between the No. 37 (30 A) fuse in the under-hood fuse/relay box and the VSA modulator-control unit.■
NO -
Install a new No. 37 (30 A) fuse in the under-hood fuse/relay box, then go to Step 9 .
  1. Reconnect the VSA modulator-control unit 36P connector.
  1. Turn the ignition switch to LOCK (0), then turn it to ON (II) again.
  1. Check for DTCs with the HDS.
Is DTC 54-03, 54-04, or 54-21 indicated?
YES -
Check for loose terminals in the VSA modulator-control unit 36P connector. If the VSA modulator-control unit was updated, substitute a known-good VSA modulator-control unit, then retest. If the VSA modulator-control unit was substituted, go to Step 1 .
NO -
If the VSA modulator-control unit was updated, troubleshooting is complete. If the VSA modulator-control unit was substituted, replace the original VSA modulator-control unit. If any other DTCs are indicated, go to the indicated DTCs troubleshooting.■