Skip to main content
VSA DTC Troubleshooting: 86-01

DTC 86-01:
 F-CAN Bus-off Malfunction
  1. Turn the ignition switch to ON (II).
  1. Clear the DTC with the HDS.
  1. Turn the ignition switch to LOCK (0), then turn it to ON (II) again.
  1. Check for DTCs with the HDS.
Is DTC 86-01 indicated?
YES -
Go to Step 5 .
NO -
Intermittent failure, the system is OK at this time. Check for loose terminals between ECM/PCM connector A (49P) and the VSA modulator-control unit 36P connector. Refer to intermittent failures troubleshooting.
  1. Turn the ignition switch to LOCK (0).
  1. Short the SCS line with the HDS.
  1. Disconnect ECM/PCM connector A (49P).
  1. Check for continuity between VSA modulator-control unit 36P connector terminal and ECM/PCM connector A (49P) terminal (see table).
    Sign
    VSA Modulator-control Unit 36P Connector Terminal
    ECM/PCM Connector A (49P) Terminal
    CAN-L
    No. 1
    No. 4
    CAN-H
    No. 14
    No. 3

Is there continuity?
YES -
Go to Step 10 .
NO -
Repair open in the wire between the ECM/PCM and the VSA modulator-control unit.■
  1. Reconnect all connectors.
  1. Turn the ignition switch to LOCK (0), then turn it to ON (II) again.
  1. Check for DTCs with the HDS.
Is DTC 86-01 indicated?
YES -
Check for loose terminals in the VSA modulator-control unit 36P connector. If the VSA modulator-control unit was updated, substitute a known-good VSA modulator-control unit, then retest. If the VSA modulator-control unit was substituted, go to Step 1 .
NO -
If the VSA modulator-control unit was updated, troubleshooting is complete. If the VSA modulator-control unit was substituted, replace the original VSA modulator-control unit. If any other DTCs are indicated, go to the indicated DTCs troubleshooting.■