Skip to main content
SRS Component Replacement/Inspection After Deployment

NOTE:
  • Before doing any SRS repairs, check the DTCs, refer to the appropriate Fit/Jazz Shop Manual, for the less obvious deployed components (seat belt tensioners, front impact sensors, side airbag sensors, etc.)
  • Do not replace the OPDS unit unless it is physically damaged or a specific fault was found during DTC troubleshooting in the appropriate Fit/Jazz Shop Manual.
After a collision where the seat belt tensioners deployed, replace these items:
  • SRS unit
  • Seat belt tensioners
  • Front impact sensors
After a collision where the front airbag(s) deployed, replace these items:
  • SRS unit
  • Deployed airbag(s)
  • Seat belt tensioners
  • Front impact sensors
After a collision where the side airbag(s) deployed, replace these items:
  • SRS unit
  • Deployed side airbag(s)
  • Side impact sensor(s) (first)
  • Side impact sensor(s) (second)
  • Center pillar lower trim
  • Complete seat frame
After a collision where a side curtain airbag has deployed, replace the items for the side(s) that deployed:
  • SRS unit
  • Deployed side curtain airbag(s)
  • Seat belt tensioner(s)
  • Side impact sensor(s) (first)
  • Side impact sensor(s) (second)
  • Front pillar trim
  • Center pillar upper trim
  • Quarter pillar trim
  • Headliner
  • Front grab handle
  • Rear grab handle
  • All related trim clips
  • Sunvisor
After a moderate to severe side or rear collision, inspect for any damage on the side curtain airbag or other related components. Replace the components as needed.
After a collision, where a side curtain airbag has deployed, replace all trim clips on that side, even if they appear to be undamaged. Replace the clips on these parts:
  • Front pillar trim
  • Center pillar lower trim
  • Quarter pillar trim
During the repair process, inspect these areas:
  • Inspect all the SRS wire harnesses. Replace, do not repair, any damaged harnesses.
  • Inspect the cable reel for heat damage. If there is any damage, replace the cable reel.
After the vehicle is completely repaired, turn the ignition switch to ON (II). If the SRS indicator comes on for about 6 seconds and then goes off, the SRS is OK. If the indicator does not function properly, use the HDS to read the DTC, refer to the appropriate Fit/Jazz Shop Manual. If you cannot retrieve a code, do the SRS Symptom Troubleshooting in the appropriate Fit/Jazz Shop Manual.