Skip to main content
Battery Terminal Disconnection/Reconnection

Disconnection
NOTE: Some system store data in memory is lost when the battery is disconnected. Do the following procedures before disconnecting the battery.
  1. Make sure you have the anti-theft code(s) for the audio and/or the navigation system (if equipped).
    NOTE: For some models, it maybe necessary to write down the audio presets (AM and FM), because the audio unit does not retain the presets after the battery is disconnected.
  1. Make sure the ignition switch is in LOCK (0).
  1. Disconnect and isolate the negative cable (A) from the battery.
    NOTE: Always disconnect the negative cable from the battery first.
  1. Disconnect the positive cable (B) from the battery.
Reconnection
NOTE: Some system store data in memory is lost when the battery is disconnected. Do the following procedures to restore the systems back to normal operation.
  1. Clean the battery terminals.
  1. Test the battery; refer to the appropriate Fit/Jazz Shop Manual.
  1. Reconnect the positive cable (A) to the battery (B) first, then reconnect the negative cable (C) to the battery.
    NOTE: Always connect the positive cable to the battery first.
  1. Apply multipurpose grease to the terminals to prevent corrosion.
  1. Install the terminal cover (D).
  1. Enter the anti-theft code(s) for the audio system and/or the navigation system (if equipped).
  1. Enter the audio presets (if applicable).
  1. Set the clock (for vehicles without navigation).