Skip to main content
Front Side Frame/Outrigger Removal

NOTE: This section explains the procedures after removal of all accessories and related parts.For accessories' and related parts' removal procedure, refer to the appropriate Shop Manual.
Mass production body welding position and number [Front side frame]
NOTE:
  • Welding symbols
    : 2-Plate spot welding/ : 3-Plate spot welding/ : 4-Plate spot welding/ : MIG plug welding/ : MIG welding L= Welding length Unit: mm (in.)
  • ( ): The number of welds
Mass production body welding position and number [Outrigger and side frame extension]
NOTE:
  • Welding symbols
    : 2-Plate spot welding/ : 3-Plate spot welding/ : 4-Plate spot welding/ : MIG plug welding/ : MIG welding L= Welding length Unit: mm (in.)
  • ( ): The number of welds
Construction
  • When removing the front side frame, leave the side frame extension, the outrigger, and the front side cross-member in place.
  • Check the side frame extension, the outrigger, and the front side cross-member position for damage. If necessary, replace them as an assembly.
NOTE:
  • When removing the outrigger, leave the inside sill extension attached to the body side.
  • Carefully drill the three welded point (A) at the joints for the tie down stiffener and outrigger.