Skip to main content
Clutch Slave Cylinder Replacement

NOTE:
  • Use fender covers to avoid damaging painted surfaces.
  • Do not spill brake fluid on the vehicle; it may damage the paint or plastic. If brake fluid does contact the paint or plastic, wash it off immediately with water.
  1. Remove the mounting bolts (A), clutch line bracket (B), and clutch line clip (C), then remove the slave cylinder (D).

  1. Disconnect the clutch line (A). Plug the end of the clutch line with a shop towel to prevent brake fluid from coming out.
    NOTE: Loosen the flare nut (B) while holding the clutch line connector (C) with a wrench.

  1. Connect the clutch line (A).
    NOTE: Tighten the flare nut (B) while holding the clutch line connector (C) with a wrench.

  1. Apply a light coat of molybdenum to the push rod (A) of the slave cylinder.
  1. Install the clutch line clip (B), clutch line bracket (C), and mounting bolts (D).
  1. Check the clutch operation, and check for leaks.
  1. Test-drive the vehicle.