Skip to main content
Vehicle moves in 2 and R, but not in 1st in D, D3, S, or 1

Probable cause(s)
  1. 1st accumulator defective
  2. 1st gears worn or damaged
  3. 1st clutch defective
Notes
  • Check the 1st clutch pressure.
  • Inspect the 1st accumulator piston, O-ring, and spring for wear and damage in the servo body.
  • Inspect the countershaft, secondary shaft, and 1st clutch for wear and damage.
  • Inspect the clutch piston, clutch piston check valve, and O-rings. Check the spring retainer for wear and damage. Inspect the clearance between the clutch end-plate and the top disc. If the clearance is out of tolerance, inspect the clutch discs and plates for wear and damage, and inspect the clutch wave-plate height. If the discs and plates are worn or damaged, replace them as a set. If the wave-plate height is out of tolerance, replace the wave-plate. If they are OK, adjust the clearance with the clutch end-plate.