Skip to main content
A/T Clutch Pressure Control Solenoid Valve B and C Replacement

  1. Remove the breather hose (A) from its clamp (B), and remove the breather hose clamp bracket (C).

  1. Disconnect the connectors (A) from A/T clutch pressure control solenoid valve B and C.
  1. Remove A/T clutch pressure control solenoid valve B and C.
  1. Remove the ATF pipe (D), ATF joint pipes (E), O-rings (F), and gasket (G).
  1. Clean the mounting surface and fluid passages of the transmission housing.
  1. Install the new gasket with blue side down; white side up on the transmission housing.
  1. Install the ATF pipe and ATF joint pipes, and install the new O-rings over the ATF joint pipes.
  1. Install A/T clutch pressure control solenoid valve B and C.
  1. Check the connectors for rust, dirt, or oil, clean or repair if necessary, then connect the connectors securely.
  1. Install the breather hose clamp bracket, and install the breather hose on its clamp at the dot.