Skip to main content
A/T Countershaft Reverse Selector Hub Installation

Special Tools Required

Driver, 40 mm I.D.
 07746-0030100
  1. Install the 1st gear, the 2nd gear, the 3rd gear, the 33.2 x 40 x 26 mm collar, the 29 mm cotters, and the 33 x 45 x 7.8 mm collar on the countershaft, and secure them with the snap ring.
  1. Install the needle bearings and the 4th-5th gear.
  1. Slide the reverse selector hub (A) over the countershaft (B), then press it in place using the driver (40 mm I.D.) and a press.
    NOTE: Some reverse selector hubs are not press-fitted, and can be installed without using the a press.