Skip to main content
A/T Housing Bearing Installation

Special Tools Required

Driver attachment, 72 x 75 mm
 07746-0010600

Driver attachment, 78 x 80 mm
 07NAD-PX40100

Driver attachment, 62 x 68 mm
 07746-0010500

Driver handle 15 x 135L
 07749-0010000

Snap ring pliers
 07LGC-0010100
  1. Install the mainshaft bearing (A), countershaft bearing (B), secondary shaft bearing (C), and idler gear shaft bearing (D) in the transmission housing in the direction shown.
  1. Expand each snap ring with the snap ring pliers, and install the bearing part-way into the housing.
  1. Release the pliers, then push the bearing down into the housing until the snap ring snaps in place around it.

  1. After installing the bearings verify that the snap rings (A) are seated in the bearing and housing grooves, and that the ring end gaps (B) are 0−7 mm (0−0.28 in.)

  1. Install the idler gear shaft (A) in the idler gear shaft bearing.
  1. Install the cotters (B) and cotter retainer (C), and secure the idler gear shaft with the snap ring (D).