Skip to main content
A/T Clutch Disassembly

Special Tools Required

Clutch spring compressor set
 07LAE-PX40000

Clutch spring compressor attachment
 07LAE-PX40100

Clutch spring compressor attachment
 07HAE-PL50100

Clutch spring compressor bolt assembly
  07GAE-PG40200

Snap ring pliers
 07LGC-0010100
  1. Remove the snap ring with a screwdriver.

  1. Remove the clutch end-plate (A), the clutch discs (B) (6), the clutch wave-plates (C) (6), and the wave spring (D) from the 1st clutch drum (E).

  1. Remove the clutch end-plate (A), the clutch discs (B) (3), the clutch flat-plates (C) (3), and the wave spring (D) from the 2nd clutch drum (E).

  1. Remove the clutch end-plate (A), the clutch discs (B) (4), the clutch flat-plates (C) (4), and the wave spring (D) from the 4th clutch drum (E).

  1. Remove the clutch end-plate (A), the clutch discs (B) (3), the clutch wave-plates (C) (3), and the wave spring (D) from the 3rd clutch drum (E).

  1. Remove the clutch end-plate (A), the clutch discs (B) (3), the clutch wave-plates (C) (3), and the wave spring (D) from the 5th clutch drum (E).

  1. Install the clutch spring compressor attachments and the clutch spring compressor bolt assembly.

  1. Set the clutch spring compressor attachment (A) on the 1st clutch spring retainer (B) so the clutch spring compressor attachment works on the clutch return spring (C).
  1. If either end of the clutch spring compressor attachment is not set over the clutch return spring end, the spring retainer may be tilted and damaged. If the retainer is tilted when compressing the return spring, reset the clutch spring compressor attachment on the retainer at another angle.

  1. Be sure the clutch spring compressor attachment (A) is adjusted to have full contact with the spring retainer (B) on the 2nd, 3rd, 4th, and 5th clutches.

  1. If either end of the clutch spring compressor attachment is set over an area of the spring retainer that is unsupported by the return spring, reset the clutch spring compressor attachment over the proper position.

  1. Compress the return spring until the snap ring can be removed.

  1. Remove the snap ring with snap ring pliers.
  1. Remove the clutch spring compressor attachments and the clutch spring compressor bolt assembly.

  1. Remove the snap ring (A), the spring retainer (B), and the return spring (C).

  1. Wrap a shop rag around the clutch drum, and apply air pressure to the fluid passage to remove the piston. Place a finger tip on the other passage while applying air pressure.

  1. Remove the clutch piston (A) from the clutch drum (B) of the 1st, 2nd, and 4th clutches. Remove the O-ring (C) from the clutch piston, and O-ring (D) from the drum.

  1. Remove the clutch piston (A) from the clutch drum of the 3rd and 5th clutches, and remove the outer O-ring (B) and inner O-ring (C) from the piston.