Skip to main content
Subfuel Solenoid Replacement

  1. Remove the bolt (A).
  1. Remove the intake manifold stay (B).
  1. Disconnect the connector (C) from the subfuel solenoid.
  1. Remove the harness band (D) from the subfuel solenoid holder (E).

  1. Place the wrench (A), then remove the bolts (B).
  1. Remove the injector clip (C) from the subfuel solenoid.

  1. Coat the new O-ring (A) with clean engine oil, and insert the subfuel solenoid (B) into the subfuel solenoid holder (C).
  1. Install the injector clip (D).
  1. Coat the injector O-ring (E) with clean engine oil, and insert the subfuel solenoid into the subfuel pipe (F).
  1. Place the wrench (G), then tighten the bolts (H).

  1. Install the bolt (A).
  1. Install the subfuel feed pipe (B), with a new O-ring (C).
  1. Reconnect the connector (D).
  1. Turn the ignition switch to ON (II), but do not operate the starter. After the subfuel pump runs for about 2 seconds, the subfuel pressure in the subfuel line rises. Repeat this two or three time, then check for fuel leakage.
  1. Install the harness band (E).
  1. Install the intake manifold stay (F).