Skip to main content
Intake Manifold Chamber Removal and Installation


Exploded View
Removal
  1. Remove the engine wire harness connectors and wire harness clamps from the intake manifold chamber.
    • Throttle actuator connector
    • Manifold absolute pressure (MAP) sensor connector
  1. Remove the brake booster vacuum hose (A) and the harness clamp (B).
  1. Remove the water bypass hose from the clamp (C).

  1. Remove the throttle body without disconnecting the water bypass hoses.

  1. Remove the intake manifold bracket mounting bolts.

  1. Remove the intake manifold chamber.

Installation
  1. Install the intake manifold chamber (A) with a new gaskets (B), and tighten the bolts in a crisscross pattern in three steps, beginning with the inner bolt.

  1. Loosen the intake manifold bracket mounting bolt (A). Tighten the mounting bolts (B), then tighten the mounting bolt (A).

  1. Install the throttle body (A) with a new gasket (B).

  1. Install the water bypass hose to the clamp (A).
  1. Install the brake booster vacuum hose (B) and the harness clamp (C).
  1. Install the engine wire harness connectors and wire harness clamps to the intake manifold chamber.
    • Throttle actuator connector
    • MAP sensor connector