Skip to main content
i-SHIFT Clutch Actuator/TCM Removal/Installation

NOTE:
  • Take care not to scratch body.
  • Use fender covers to avoid damaging painted surfaces.
  1. Remove the battery harness clamps (A), then release the lock and remove the clutch actuator connector (B).
  1. Remove the battery base bolts (C) and the reservoir tube (D), then remove the battery base (E).

  1. Remove the bolts (A) from the slave cylinder (B) so as not to bend the clutch line.

  1. Remove the clutch reservoir tank (A) from the bulkhead (B).
    NOTE:
    • Do not spill brake fluid from the reservoir tank.
    • When remove the reservoir tank, fix the reservoir tank by hand.

  1. Disconnect the clutch actuator connector (A) and the ground cable (B).

  1. Release the lock and remove the transmission shift change actuator connector (A), then remove the transmission shift change actuator harness cover (B) and the harness clip (C).

  1. Disconnect the transmission shift change actuator connector (A).
  1. Raise the vehicle, and make sure it is securely supported.

  1. Loosen the bolts (A), then remove the clutch actuator (B) with the clutch pipe comp (C) and the clutch fluid tube assembly (D).
  1. Install the clutch actuator in the reverse order of removal.
  1. Test-drive the vehicle.