Skip to main content
i-SHIFT Clutch Fluid Tube Assembly Replacement

NOTE:
  • Use fender covers to avoid damaging painted surfaces.
  • Do not spill brake fluid on the vehicle; it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
  1. Raise the vehicle, and make sure it is securely supported.
  1. Disconnect the clutch fluid tube (A) from the clutch actuator (B). Plug the end of the clutch fluid with a shop towel to prevent brake fluid from coming out.
  1. Lower the vehicle, and make sure it is securely supported.

  1. Remove the clutch reservoir tank (A) from the bulkhead (B), then remove the reservoir tube (C) from the clips (D). Replace to the new clutch fluid tube assembly.

  1. Install the clutch reservoir tank (A) on the bulkhead (B), then install the reservoir tube (C), from the clips (D).
    NOTE:
    • Make a mark (E) on this side and insert the tube into the clip.
    • When install the reservoir tank, fix the reservoir tank by hand.
  1. Raise the vehicle, and make sure it is securely supported.

  1. Connect the clutch fluid tube (A) on to the clutch actuator (B).
    NOTE:
    • Match the mark of tube (C) with the mark of grommet (D).
    • Install the tube till the mark is matched to the protrusion of tube.
    • Application of oil is not allowed.
  1. Check the clutch operation and check for leaking fluid.
  1. Test-drive the vehicle.