Skip to main content
i-SHIFT Gear Shift Control Module Replacement

NOTE: LHD model is shown, RHD model is similar.
  1. Disconnect the connector (A), then remove the gear shift control module (B).
    NOTE: If the gear shift control module needs to be replaced, remove the shift lever knob (C) from the gear shift control module.

  1. Install the gear shift control module (A), then connect the connector (B).
    NOTE: If the gear shift control module was replaced, install the shift lever knob (C) to the gear shift control module (turn the shift lever knob clockwise for 11 to 13 times, and make sure the shift pattern on the knob is at the right place).
  1. Test-drive the vehicle.