Skip to main content
M/T Clutch Housing Differential Thrust Clearance Adjustment

Special Tools Required

Inner driver handle, 40 mm
 07746-0030100
  1. Install the 80 mm shim that's the same size as the one you removed.

  1. Install the differential assembly into the clutch housing.
  1. Specified Torque:
    8 x 1.25 mm 27 N·m (2.8 kgf·m, 20 lbf·ft)


  1. Use the special tool to bottom the differential assembly in the clutch housing.

  1. Measure clearance between 80 mm shim and bearing outer race in transmission housing.
    Standard:
    0.01−0.10 mm (0.0004−0.0039 in.)

  1. If the clearance is more than the standard, select a new shim from the following table. If the clearance measured in step 5 is within the standard, go to Step 9 .

    80 mm Shim

    Type
    Part Number
    Thickness
    A
    41441-PL3-B00
    1.00 mm (0.039 in.)
    B
    41442-PL3-B00
    1.10 mm (0.043 in.)
    C
    41443-PL3-B00
    1.20 mm (0.047 in.)
    D
    41444-PL3-B00
    1.30 mm (0.051 in.)
    E
    41445-PL3-B00
    1.40 mm (0.055 in.)
    F
    41446-PL3-B00
    1.50 mm (0.059 in.)
    G
    41447-PL3-B00
    1.60 mm (0.063 in.)
    H
    41448-PL3-B00
    1.70 mm (0.067 in.)
    J
    41449-PL3-B00
    1.80 mm (0.071 in.)
    K
    41450-PL3-B00
    1.05 mm (0.041 in.)
    L
    41451-PL3-B00
    1.15 mm (0.045 in.)
    M
    41452-PL3-B00
    1.25 mm (0.049 in.)
    N
    41453-PL3-B00
    1.35 mm (0.053 in.)
    P
    41454-PL3-B00
    1.45 mm (0.057 in.)
    Q
    41455-PL3-B00
    1.55 mm (0.061 in.)
    R
    41456-PL3-B00
    1.65 mm (0.065 in.)
    S
    41457-PL3-B00
    1.75 mm (0.069 in.)

  1. Remove the bolts and transmission housing.
  1. Replace the thrust shim selected in step 6, then recheck the clearance.
  1. Reinstall the transmission.