Skip to main content
DTC Troubleshooting: P0942 (163-4)

DTC P0942:
 Clutch Hydraulic System Malfunction
  1. Turn the ignition switch to ON (II).
  1. Clear the DTCs with the HDS.
  1. Change the shift lever in D.
  1. Check for DTCs with the HDS.
Is DTC P0942 indicated?
YES -
Go to Step 5 .
NO -
Intermittent failure, the system is OK at this time.■
  1. Turn the ignition switch to LOCK (0).
  1. Make sure the clutch fluid is full in the reservoir, then check the clutch hose and line joint for leaks.
Is it OK?
YES -
Go to Step 7 .
NO -
Replace the hose or tighten the joint if necessary.■
  1. Turn the ignition switch to ON (II).
  1. Change the shift lever in N.
  1. Do the CLUTCH ACTUATOR FULL STROKE OPERATION in the FUNCTIONAL TEST MENU with the HDS.
  1. Check the CLUTCH POSITION ACTUAL in the DATA LIST with the HDS.
Is there more than 15 mm (0.6 in.)?
YES -
Check for these conditions, and repair if necessary:■
  • Clutch disc and pressure plate
  • Diaphragm spring
  • Release bearing
NO -
Check for these conditions, and repair if necessary:■
  • Slave cylinder
  • Release fork