Skip to main content
DTC Troubleshooting: P19E4 (162-8)

DTC P19E4:
 Gear Shift Actuator Temperature Out of Range
NOTE: DTC P19E4 is stored when the gear change motor is protection mode. This can be caused due to frequent UP/DOWN operation. In this case, it is not a malfunction.
  1. Check whether the driver changed gears excessively while driving.
Did the driver change gears excessively while driving?
YES -
Not failure, just a rise of the transmission shift change actuator temperature due to excessive gear changes.■
NO -
Go to Step 2 .
  1. Turn the ignition switch to ON (II).
  1. Clear the DTCs with the HDS.
  1. In order to cool the system, wait for at least 1 hour.
  1. Test-drive the vehicle for at least 10 minutes.
  1. Check for DTCs with the HDS.
Is DTC P19E4 indicated?
YES -
Go to Step 7 .
NO -
Intermittent failure, the system is OK at this time.■
  1. Turn the ignition switch to LOCK (0).
  1. Check if the shift arm (A) moves smoothly.
Does the shift arm move smoothly?
YES -
NO -
Repair the transmission internal failure.■