Skip to main content
DTC Troubleshooting: P19E7 (160-27)

DTC P19E7:
 Clutch Contact Position 3 Learning Not Completed
NOTE: If the Clutch Contact Position 3 Learning is incomplete after replacing the clutch disc, repeat the Clutch Contact Position 3 Learning several times. If the Clutch Contact Position 3 Learning is still incomplete, check the clutch disc installation.
  1. Turn the ignition switch to ON (II).
  1. Clear the DTCs with the HDS.
  1. Start the engine. Hold the engine speed at 3,000 rpm (min −1 ) without load until the radiator fan comes on, then let it idle.
  1. Turn the headlight switch to ON.
  1. Check for DTCs with the HDS.
Is DTC P19E7 indicated?
YES -
Go to Step 7 .
NO -
Intermittent failure, the system is OK at this time.■
  1. Turn the ignition switch to LOCK (0).
  1. Check for DTCs with the HDS.
Is DTC P19E7 indicated?
YES -
Go to Step 8 and repeat the steps.
NO -
Clutch Contact Position 3 Learning is complete.■