Skip to main content
DTC Troubleshooting: P19EE (150-23)

DTC P19EE:
 Shift Actuator Motor Rotating Pulse/Rotating Direction Sensor Supply Signal Circuit High Voltage
  1. Turn the ignition switch to ON (II).
  1. Clear the DTCs with the HDS.
  1. Turn the ignition switch to LOCK (0).
  1. Turn the ignition switch to ON (II).
  1. Check for DTCs with the HDS.
Is DTC P19EE indicated?
YES -
Go to Step 6 .
NO -
Intermittent failure, the system is OK at this time.■
  1. Turn the ignition switch to LOCK (0).
  1. Disconnect the shift actuator motor 6P connector.
  1. Turn the ignition switch to ON (II).
  1. Measure voltage between the shift actuator motor 6P connector terminal No. 3 and body ground.
Is there battery voltage?
YES -
Repair a short to power in the wire between the TCM (B20) and the shift actuator motor.■
NO -