Skip to main content
DTC Troubleshooting: P19F6 (154-22)

DTC P19F6:
 Select Actuator Motor Position Sensor Ground Line Open
  1. Turn the ignition switch to ON (II).
  1. Clear the DTCs with the HDS.
  1. Turn the ignition switch to LOCK (0).
  1. Turn the ignition switch to ON (II).
  1. Check for DTCs with the HDS.
Is DTC P19F6 indicated?
YES -
Go to Step 6 .
NO -
Intermittent failure, the system is OK at this time.■
  1. Turn the ignition switch to LOCK (0).
  1. Disconnect the select actuator motor 6P connector.
  1. Disconnect the change actuator subharness B 10P connector.
  1. Check for continuity between change actuator subharness B 10P connector terminal No. 8 and select actuator motor 6P connector terminal No. 2.
Is there continuity?
YES -
Remove the clutch actuator assembly, and check for change actuator subharness A. If the wire harness is OK, replace the transmission shift change actuator.
NO -
Repair an open in the wire of the change actuator subharness B.■