Skip to main content
DTC Troubleshooting: P19FC (160-23)

DTC P19FC:
 Shift Change Actuator Position Learning Not Completed
NOTE:
  • DTC P19FC is stored when the Shift Change Actuator Position Learning is incomplete.
  • Make sure the battery is fully charged.
  1. Turn the ignition switch to ON (II).
  1. Clear the DTCs with the HDS.
  1. Check for DTCs with the HDS.
Is DTC P19FC indicated?
YES -
Go to Step 3 , and repeat the steps. If DTC P19FC is stored again after doing the i-SHIFT System Learning (Static Mode), check the repair error, or there is a problem in a replacement part.
NO -
Intermittent failure, the system is OK at this time.■