Skip to main content
M/T Assembly Installation

Special Tools Required

Engine support hanger
 AAR-T-1256-J00
NOTE: Use fender covers to avoid damaging painted surfaces.
  1. Make sure two dowel pins (A) are installed in prescribed hole on the engine block as shown.
  1. Place the transmission on the transmission jack, and raise it to the engine unit level.

  1. Install the lower transmission mounting bolts.

  1. Install the clutch case cover.

  1. Install the torque rod bracket with new bolt (A) and bolts (B).

  1. Loosely install the torque rod new bolt (A), new nut (B) and new bolt (C), then remove the transmission jack.

  1. Install the heat cover.
  1. Lower the vehicle on the lift.

  1. Tighten the new transmission mount bolts (A), three new engine mount nuts (B), and ground cable (C) to the specified torque value.

  1. Loosen the wing nut (A). Remove the hook (B) and engine support hanger (C) from the vehicle.

  1. Remove the hanger plate (A) to the air cleaner stay (B) with the 8 x 1.25 mm bolt (C). Install the purge control SOL.V. hose (D).

  1. Tighten the torque rod with the bolts and nut to the specified torque value.

  1. Install the one upper transmission mounting bolts.

  1. Connect the vehicle speed sensor (VSS) connector.

  1. Apply a light coat of silicone grease to the cable ends (A), and connect the cable end to the change lever assembly (B), then install the shift cable bracket (C), harness clip (D) and the lock pins (E). Do not bend or damage the shift cables.
    NOTE: When you apply the silicone grease, make sure not to adhere to the terminal part of connectors and surrounding switches. Also do not touch the switches and the terminal part of connector by hands or glove that adheres the silicone grease.

  1. Connect the back-up light switch connector (A), then install the harness clip (B).

  1. Apply a light coat of molybdenum grease to the end of the slave cylinder rod (A). Install the slave cylinder (B) and clutch line bracket (C). Install the clutch line in the clip (D). Take care not to bend the clutch line.

  1. Install the battery base (A) and harness clip (B).

  1. Install the air cleaner stay.
  1. Test-driver the vehicle.