Skip to main content
Honda Fit Jazz GE6 GE8
M/T Clutch Housing Countershaft Bearing Replacement
Special Tools Required
Adjustable bearing remover head, 20−40 mm
Bearing remover shaft
Sliding hammer weight
Driver handle, 15 x 135L
Bearing driver attachment, 52 x 55 mm
Remove the needle bearing (A) using the 20−40 mm adjustable bearing remover head (B), sliding hammer weight (C) and bearing remover shaft (D), then remove oil guide plate C (E).
Position the oil guide plate C (A) and new needle bearing (B) in the bore of the clutch housing (C).
Press in the needle bearing using the 15 x 135L driver handle (D), 52 x 55 mm bearing driver attachment (E).